20w Perfect Laser/ Maxphotonics Fibre laser question

LightBurn Hardware Compatibility Galvo
1

Hi All

I have a little 20w Q-switched fibre with maxphotonics laser source that I would like to use with Lightburn as the MaxMarking software that comes with it is fairly rubbish. I don’t believe this source is yet supported so was wondering if it’s viable to swap out the controller for a Ezcad2 board. Does anyone know if this is possible?

Thanks

Mark

2

A pic of the control board may be informative.

I haven’t swapped a Galvo control board yet.

3

I shall investigate as soon as I’m next in front of the machine and provide further detail.

Many thanks

4

This is the laser in question - Perfect Laser small mini fiber laser marking engraving machine

5

image
image623×806 108 KB

This appears to be the laser source it uses.