We have a 25 point corfile that works perfectly on EZCad. Everytime I load it onto lightburn it says the file is corrupt. A 9 point calibration loads, however we have not been able to get that accurate enough on this machine. I’ve tried remaking the file several times and redoing the 9 point and always get the same result.
LightBurn does not yet support 25 point COR file import. If you wouldn’t mind emailing your COR file to support@LightBurnSoftware.com it would help us in gathering a selection of them to decode.
1 Like
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.