3018 laser only fires at full power

[Rick (Technical Evangelist)]

@Douglas

If I knew how to write this command for a macro I would not have to go back into Easel.

Right-click the desired button to open the ‘Edit Macro’ window to define the commands this ‘Macro’ button with execute.

And further here:

Setting up tool on/off gcodes

There are two locations to enter GCode commands directly, the ‘Console’ by typing into the edit window and hitting Return / Enter or place that into a macro. These are used to change the firmware setup for use. [image] The second is designed to provide pre and post, per job GCode as you request. [image]