Hi
I have a few issues on hand
I’ve got a woodpecker motherboard as well an annoy tool motherboard. Ive got a neje 30w laser module. My lightburn version is 0.8.07
Woodpecker
My first problem is my 30w laser, when plugged into the woodpecker boots up immediately.
1)however the 30w laser does not fire when given a job. Or with the fire button for that matter.
2)also the collaborations are off.
(My engraver size is 1m/1m.) what are the best console settings please.
Here are my console settings
Woodpecker
$$
$0=10
$1=25
$2=0
$3=2
$4=0
$5=0
$6=0
$10=1
$11=0.010
$12=0.002
$13=0
$20=0
$21=0
$22=0
$23=3
$24=25.000
$25=500.000
$26=250
$27=0.000
$30=1000
$31=0
$32=1
$100=800.000
$101=800.000
$102=800.000
$110=1000.000
$111=1000.000
$112=600.000
$120=30.000
$121=20.000
$122=0.000
$130=200.000
$131=200.000
$132=200.000
Annoy tools
$$
$0=10
$1=255
$2=0
$3=6
$4=0
$5=0
$6=0
$10=3
$11=0.020
$12=0.002
$13=0
$20=0
$21=1
$22=1
$23=4
$24=25.000
$25=500.000
$26=250
$27=2.000
$30=1000
$31=1000
$32=1
$100=80.000
$101=80.000
$102=800.000
$110=1000.000
$111=1000.000
$112=100.000
$120=5000.000
$121=20.000
$122=20.000
$130=800.000
$131=800.000
$132=200.000
ok
3) my limit switches are not working with the woodpecker motherboard.
Annoy tools
The 30w laser does not boot up when connected to the annoy tools motherboard. However it used to sometime back. But it seems that there is little voltage going through it. It doesn’t fire even when I press the test fire button on the mini board.
Note* when I enter G1 M3 S1000 into the console settings the laser boots up but like on the woodpecker but Much quieter. Still it doesn’t fire!
It seems that my limit switches have stopped working too on the annoy tools board but that was the case before.
My collaborations are working better than the woodpecker. Especially when the laser module is brought to the right corner before it’s turned on.
How do I please get my laser to fire?