5W UV Engraving inside glass doesn't fill

[Aaron.F (Aaron)]

---

I don’t know much about the physics involved with subsurface engraving, but the glass used seems to make a big difference.

As discovered by @cloxart in this thread Omni X crystal engraving inside a sphere? - #24 by cloxart

---

@unicornmafia

I had an aluminum business card under it, and it engraved the fill on the card instead of inside the crystal.

So the Lines engraved inside, and the Fill Sub-Layer went through the crystal engraved on the business card?
This is odd. I’m asuming, you didn’t change the focus. Can you confirm that?

@unicornmafia

I think it’s just somehow not getting the same energy density in fill mode as it does in line mode

Both the Fill and Line Sub-Layers appear to use the same intensity settings.

Does it make a difference if you create a new separate Layer in fill mode?