I did find this after I posted: Camera in edge is not focused
I am REALLY glad for what you guys have done, but I do wish some of this stuff was better documented. I feel like going through a needle in a haystack…for the last few hours.
I’d like to suggest adding a few info links in the software that would take you through the camera installation/focus/etc. There’s a lot of knowledge here, but it’s not linked to lightburn software.
Also, for the dot pattern, I still find it difficult to perform. It would be nicer if we can do it with the camera mounted and a pattern printed out and placed on the laser bed. Also, I’d rather see a grid overlay for the part of the screen we were supposed to be calibrating (I think Oz mentioned tick tack toe…gray out the rest of the screen, and show a box where the image needs to be displayed…the photos in the demo are confusing since that lid is closed).
I’ll play with it some more tomorrow