I know that there is the possibility to connect two laser machines at only one computer and both laser can be controlled by LB changing com port, but the question is this: assuming that both my controllers (A and B) can’t work off line (there is no SD slot) if i start a work on A can i, while A is e…

No, not at this time, the communication channel within LightBurn can stream to one laser at a time. You can start a job, then start the prep for the next laser, but currently, LightBurn will only communicate with a single connection at a time. :slight_smile:

A question about Lightburn

LightBurn Software Questions

Rick (Technical Evangelist) November 23, 2021, 1:34am 9

There are a few commands we have surfaced via SendUDP as described below. We do plan to extend and offer additional access, but that will take time.

1 Like