Hi I don’t know if any one has mentioned this but sometimes absolute cords changes on my machine it took a while to find out what was going on I have always had absolute co0rds displayed in the program I will have to cut make new page then past then it is not working. it sends the laser head right to the limit edge not to where the job is on my layout it displays a small layout on my RUIDA. when its working I noticed the display screen is A large image I am using 1.3.00 this has only happened since update to 1.3.00.
Kind Regards
Max
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.