Seen quite a few people lately talking about Lightburn locking up and becoming unresponsive. Don’t know if this is anything to do with it but ya never know. Today I accidently clicked the Stop button while LightBurn was’nt even doing anything and it locked up. Had to close it and restart it. Nothing else would get it to work. Just wondered if it’s me or it’s a problem with the program. The thing is it does it on both my computers, one with my laser connected and one with just the hardware connected but no actual machine, I just use that one for testing and designing stuff. I should say I have the latest version 0.9.14
Clicking ‘Stop’ on a gcode system will cause LightBurn to wait for a response to the command, but one never comes, which is why it requires a reset of the controller. This is fixed already for 0.9.15.
Ok. Thanks very much Oz.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.