Hello, I have a ACMER P1. I’m very new to lasers and lightburn. I was using it just fine (laser and software) and now when I send something to the laser, it will do it, but nothing prints or engraves or cuts or anything. All my values are set appropriately, But i was messing with setting that i dont remember trying to engrave on an aluminum can .
please help.
Since we dont know what you did or are trying to do, how about some basic info to start?
Please post a screenshot (not a cell phone pic) of your entire Lightburn screen with your project loaded and the Cuts/Layers Panel and Laser Panel visible. Also post a screenshot of the Settings Window (Gears icon) with the Units and Grids tab visible and post a screenshot of the Device Settings Window (Wrench and Screwdriver icon).
Hi, i dont know how to take a screenshot.
What I see there looks normal, but you didn’t show what I asked for.
No can do with a diode laser, if that is what you were trying.