After my device is located the Z axis just keeps going down

I’m running Windows 10. I just installed the software. But after it finds my device the Z axis just keeps trying to go down. It shows busy busy in the laser window but I haven’t given it anything to do and it doesn’t respond when i push pause or stop

You might’ve told LightBurn to home your machine, and it’s possible that your machine doesn’t have a homing / limit switch on the Z axis, which would prevent that from working unless you have a special build of GRBL with the Z homing disabled.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.