@madsci, there is some confusion apparently (and I’ve had it too) about how that cut mode setting works now.
Checked or unchecked, the value of the delay will still be applicable. Therefore you can still pause the start while not having the laser fire. Make sure the value of the delay is 0.
Also, I recall another report of a potential problem with this and it affecting a fill layer…
Let me find that link and I’ll add it to this post… (please hold while we connect you to the next available)…
Yep… here it is. So basically for now, change the fill layer to line, set dwell time to 0, OK to set layer, then change layer back to fill. I think maybe all you need to do is to make sure dwell is off to correct this: