I bought the Ortur Laser Master 2 10amp machine new in the fall of 2022, but have just recently set it up. I have not been able to get it to do anything except “home” thus far.
Here’s what I get when trying to get it to “frame” or “start” my sample creation:
Starting stream
ALARM:2
G-code motion target exceeds machine travel. Machine position safely retained. Alarm may be unlocked. (Right-click the ‘Devices’ button to reset the connection)
On or near line 0:
Ortur Laser Master 2 Pro S2 Ready!
OLF:OLF 188.
OLH:OLM_ESP_PRO_V1.2.
OLM:GENERAL.
[MSG: Flame detector active,Ambient infrared value:0]
Grbl 1.1f [‘$’ for help]
[MSG:‘$H’|‘$X’ to unlock]
[MSG:Caution: Unlocked]
ok
$$
$0=5.0
$1=100
$2=0
$3=6
$4=7
$5=7
$6=1
$10=2047
$11=0.050
$12=0.002
$13=0
$14=6
$15=0
$16=1
$17=4
$18=0
$19=0
$20=1
$21=1
$22=1
$23=7
$24=600.000
$25=3000.000
$26=100
$27=3.000
$28=0.100
$29=0.0
$30=1000.
$31=0.
$32=1
$33=1000.000
$34=0.000
$35=0.000
$36=100.000
$37=0
$39=1
$40=1
$41=0
$42=1
$43=1
$44=3
$45=0
$46=0
$56=1.000
$57=1800.000
$58=395.000
$59=6000.000
$60=0
$61=0
$62=0
$63=3
$64=1
$65=0
$100=80.000
$101=80.000
$102=2124.000
$110=10200.000
$111=10200.000
$112=600.000
$120=2200.000
$121=1800.000
$122=200.000
$130=400.000
$131=400.000
$132=100.000
$259=0
$260=70
$261=150
$262=150
$263=0
$264=0
$265=50
$266=100
$267=0
$268=0
$269=0
$270=5120
ok
can you post a full screenshot of your lightburn with the design you are trying to run?
specially what “start from” are you using?
The problem seems to be you told lightburn you have the extension but not the firmware
in console type
$131=800
press enter
REtry
It moved, but not where I was expecting it to go.
<Idle|MPos:113.288,623.375,0.000|Bf:35,7679|FS:0,0|Pn:PY|CL:0,100|PS:2,1|ER:0,0|VA:23967,1|A:S>
[GC:G0 G54 G17 G21 G90 G94 G49 G98 G50 M5 M9 T0 F6000 S20.]
ok
Starting stream
Stream completed in 0:03
tried again, and it worked. Thanks!
great news
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
