ALARM:2 G-code motion target exceeds machine travel. Machine position safely retained. Alarm may be unlocked. (Right-click the 'Devices' button to reset the connection) On or near line 0: Job halted

[Hounddog (Mike Walker)]

I am getting ALARM:2
G-code motion target exceeds machine travel. Machine position safely retained. Alarm may be unlocked. (Right-click the ‘Devices’ button to reset the connection)
On or near line 0:
Job halted.

I need help how to fix it. Also my Ortur master 2 pro has limit switch but when i move it the red dot is not moving and I’m getting out of bounds warning. Before the red dot would move where i need it to be. I am running the latest Lightburn software. Please Help.

[berainlb (PY)]

There are many similar Topics on this forum that address this issue.

I’d suggest starting here:

OLM3 Getting Error -> ALARM:2 G-code motion target exceeds machine travel

Enable “Out of bounds warning” in Edit->Device Settings. That may warn you before you get into this situation. You should never get this alarm if you follow these conditions: You home the machine before each session You use jogging controls exclusively. Do not move the laser head by hand after homing. You don’t ignore any warnings Additionally, using Absolute Coords as your Start From mode makes this much simpler.

@Hounddog

Also my Ortur master 2 pro has limit switch but when i move it the red dot is not moving and I’m getting out of bounds warning

What exactly are you moving?

And where is the red dot that you’re referring to?