I assume you have overscan in the Cut setting. I think what’s happening is caused by your speed setting. 7500 mm/s is absurdly fast. That’s 450,000 mm/minute which is likely causing an extreme overscan. You should be able to see this in Preview.
I’d recommend 2 things:
- change your units to mm/min. You can do this in Edit->Settings
- Reduce your speed to something more reasonable like 1000 mm/minute (~15 mm/s). You can adjust this later once you get past this hurdle.
If that’s not the issue, can you test this with a simple rectangle rather than the image. That will simplify the troubleshooting process. Then upload the .lbrn file here.