In the past, I had no problem with it homing… I could set up my part for engraving or cutting, click home and it would return to my home origin I had set up… now, it just moves forward until it homes the Y axis homing button but not the y axis button…
So, while typing out the response above… I had a thought… this started acting up when I tried to set up my rotary device. I started checking all my switches, plugs and wiring, including the old wiring harness that had been connected to the rotary tool. The rotary tool had indeed shorted out and burnt one of the wires that plugs into the y axis and also burnt connects to the stop switch and I have a burnt spot on the stop switch board. After replacing the stop switch with a new stop switch from a parted out ortur machine I had. It will now home correctly.