Alarm lock when jogging

LightBurn Software Questions
1

Hi,

I have an Emblaser 2 (Build date: Jan 18 2020 09:58:50, MCU: System Clock: 100MHz E2/Core Firmware v126) and am running Lightburn 1.5.04.

Everytime after I turn on, if I try to jog I will get an Alarm Lock error -

error:Alarm lock
<Alarm|MPos:0.0000,300.0000,50.0000|WPos:0.0000,300.0000,50.0000|F:0.0,100.0>
ok
Starting stream
error:Alarm lock
On or near line 0:
error:Alarm lock
On or near line 0:
Stream completed in 0:00
error:Alarm lock
error:Alarm lock
ok

What I have to do is to click Stop a few times and then I can jog or start a job.

Would appreciate any assistance in resolving this.

Thanks
Steve

2

Darkly has a troubleshooting page on that error message here:

I think your best bet is going through that page, and, if none of the suggestions resolves the issue, contacting Darkly directly.