Algolaser Alpha 22w yellow light and not moving

I’m new to diodes, and finally upgraded from an entry Acmer P1. Got this 22w model from Algolaser for light cutting and faster engraving.

I assembled it and connected everything to my computer, but it did move, and it’s just blinking in a yellow/red light. Checked the manual, and didn’t help much.

I’ve tried installing the drivers, but just as the files finish transferring, my computer stops detecting the laser and when I plug it back in, the files aren’t actually on the machine.

This time out disconnect can be cause by the Windows USB energy saver setting. You will have to go into Windows and turn it off.

You talking about the drivers on your PC?

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.