My problem im sure is me few years ago i up dated my ortir 5 watt laser with a lu2-10a 10 watt laser was never happy the way it cut not twice the power or spped it finaly crap out crack outer lens bubble on inner lens yhought maybe i just got a dud bought after market no longer on website perhaps counterfit so got new from amazon said suppy from ortur same thing have to go 25 mmpm to cut 3.5 mm plywood at 100% power i have screen shot some of the settings i think have something to do with it please help if anyone needs to look at differnt setting let me kno
First thing to check is the focus - it very well may be different focal length between different laser modules.
Also read along:
Cause you´re talking mm/m but seems the Units are set as in/mm.
the lu2-10a has a kickstand to adjust focus
Kickstands are usually built based on an average, you can get 2 modules from the same manufacturer with Identical specs, and the actual ideal focal length can var by 1-3mm. Each module you really need to do a ramp test on if you are after best results possible, then you can worry about other settings for fine tuning.
The additional settings tab only governs the Preview/Sim timing (used for job time estimates) it does not affect your laser output. I’d recommend verifying your units via @parsec’s referenced post here: PSA: Unit Settings Changes in LightBurn 2.1 – LightBurn Software