Atomstack R30 V2 Don't want to rife

LightBurn Hardware Compatibility
,
1

Hi
Just connected the laser to Lightburn and trying to do an engraving but don’t want to start working. I set device to GRBL, 100% power and low speed.
Also tried it with AtomStack Studio. The same problem when I send order to engrave blue lamp don’t turn on. Only the green light is constantly on.

Console.txt (836 bajtów)
Gcode.txt (354 bajty)

2

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.