The weather has been too hot to work in yard or woods so I have been firing up the laser.
My set-up: Omtech CO2 60W/50W, 5200 Chiller, assist air connected through dryer to my shop compressor, and I am on a Mac with LB.
Speed 225, power 45%, amp load variable from 3mA - 8mA while engraving. When cutting speed 7-10, power 50%, 8mA - 14mA. Material is 1/8" White Birch both sides with MDF core .
I have two exhaust fans connected directly to the laser.
The engraving turned out awesome! The edges nearly had me fooled. I thought it was a layered frame but zooming in it looks like its all part of the engraved image on a flat piece of wood.
I have been known to train the wild deer to approach me when I feed them. Our dogs, present, future, passers bye have always been “rotten.” This one, “FERGY” is another special.
