AWC 608 and air assist

[JohnJohn (John Johnson)]

@dean448

air assist clarification’

This link?

Air Assist Clarification

I have searched but I wasn’t sure of the answer… Does the air assist toggle switch in Lightburn have any effect with Trocen controllers? I have an AWC708S and it doesn’t seem to make any difference - my solenoid is connected to Out 2. It is working fine but the software switch doesn’t seem to make any odds. Didn’t seem to do anything with my TL-3120 either. Also not getting the expected output from the Out 1 port. I see ~9.5V between Out 1 and Gnd. Which drops to 0V when a job is started. I…

It’s showing that it’s for an AWC708S. In your experience are they sufficiently similar?