Bare Acrylic: Film or Tape or Something?

Hey LB Gang, I need to laser cut a stack of bare acrylic (no backing on it), is there a good film or tape that I can use to cover the material before I laser cut it so that it will not fog up and get messy? I’ve used (low stickiness) painters tape successfully but I’m worried that I may be kicking up toxic fumes when cutting and etching over it.
I looked for such a tape or film on Amazon and couldn’t find any. Any advice is greatly appreciated.

nova 51

Hi, Low tack paper transfer tape as used in vinyl cutting should be ok.