I’m trying to burn an intricate but equal design but it stops when it’s finished the 1st quadrant. The preview shows all four quadrants in the play through. The design is a corner decoration that meets in the middle of both axis leaving a blank in the middle.
Can anyone Help please.
can you post your project to let us inspect and try to replicate issue?
I shall try to post the project if I can figure how to.
Save the file as lbrn and post it here
I think I’ve found the problem. May have been a rogue limit switch. Un plugged them all and so far so good.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.