Newbie rookie fresh from the press here.
I’m trying to do the camera alignment on a Lasermatic XW. Everything seems fine until I hit “Start” to engrave the alignment patterns.
A message pops up to tell me that some patterns are outside the work area, and will be removed from engraving.
The alignment pattern also shows up in the work area window, and sure enough, a tiny but of all four circles are outside work area.
I’ve checked that the work area size is correct; 610x390mm.
Tried googles, but no dice. Hope someone can point me in the right direction.
Merry Christmas!
Also! I’m following this video: https://www.youtube.com/watch?v=0yn5U5i-NaY
I’ve set scale to 195, as said in the video.