I am using this USB camera. I got it set up really well, accurate enough for my skillset. But ever since I added a new Infrared module to Lightburn by adding a new Device, because I do not care to change the basic device settings and toggle on and off various differences between my diode and IR mod…

Can you confirm that you’re using fresh target markers for the camera alignment process? Also, from looking at the screenshot it’s not apparent to me that the capture is incorrect. Are you saying there are addressable portions of the bed that aren’t showing there?

Last week, I re-calibrated my camera and burned a new target then. It worked just fine, until I started changing device settings for a new module. I believe this means it is a fresh target. Perhaps a fresh reinstall would help. The images above - the first frame shows only the target, which is a 1…

[image] JNECreations: it showed the entire laser unit and even some of the walled enclosure This is actually unexpected. It should only show you the addressable part of your laser. Literally the area of the bed that directly correlates to the workspace. [image] JNECreations: Perhaps a fr…

LightBurn Software Forum

Camera Calibration and Alignment woes

LightBurn Hardware Compatibility Cameras