Camera Calibration Crash

Hello Everyone:

I’m having a very frustrating issue when trying to calibrate my camera. When I click “Capture” I run into an issue where Lightburn Freezes and I have to close it down. I’ve tried running with Administrator privileges but no luck. I have a Windows 10 Operating System running an LS-1420.

I hope I can get this straightened out as I can not use my camera because of it.

Thanks in advance…

Michael K.

Most likely you have a honeycomb bed, and the camera code is confusing it for a lot of extra circles. If you cover the honeycomb with something (a sheet, some cardboard, wood, etc) it should behave itself.

Okay, I’ll give that a shot. Thanks for the quick reply!

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.