Camera does not see whole bed in Windows, but is fine on a Mac

The Camera does not see whole bed in Windows, but is fine on a Mac, its missing 20mm from the front and about the same from the back, so I am only seeing 360mm of a 400mm bed, the X axis is fine and can see in excess of 550mm.
Any ideas?

How do you have the camera mounted ?

What camera is it ?

Information about using a camera with LightBurn is available in our documentation here: Camera Installation and Focusing - LightBurn Documentation

Its mounted in the lid of the engraver, its an Acmer P3

OK, fair. Can you tell us what camera you are using ?

Its not the camera, its somthing in windows, another windows laptop and a macbook don’t have a problem

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.