Hello Everyone just wondered if anyone can try and help me out with my little problem with the camera alignment.
i have a 700x500 bed and am using this camera…
8MP USB Camera Module 77 Degree Wide Angle IMX179 15FPS 3264X2448 Auto Focus
it is in a camera mount on the inside of my door please see photos
everything is working done the lens and the alignment but when click on the laser to move to a point i am about 2in below the target…
i have used the x and y shift in lightburn and got it to line up but i would like to know why it is doing that
and how i can get it so i can have the x and y settings in lightburn back to zero
hope i have explained this correct please see photos attached