Camera setup, advice requested

Hi, just recently got into laser software and haven’t located a response so I am reaching out as I would appreciate your assistance.

Am setting up camera and have two inquires:

1- Does the camera need to view the whole work area OR can I position the camera on only a portion of the work area where I intend to make the most use of the camera software features.

2- Went into settings and selected the rotate 90deg. (my work area is taller then it is wide) but the camera preview doesn’t change. The camera view did however rotate for captures during camera calibration but no where else. (I have not reached the camera alignment stage yet).

Thanks for your time.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.