Camera setup questions

I setup a 5mp 160 camera (similar to the light burn camera)

This went extremely well all configuration with the dot pattern I got anywhere from .05 to .07
The issue seems to be when I to a snapshot with my material in place, I then do my design on but I when I got o frame thd image is not fully on the material? Does that make sense?? Do I not have the camera high enough over the bed? I am using a Ortur LM2 Pro (I am a noob) have only had this thing for 2 months

Any idea as to what I need to do to make sure my material IE a 6x6 tile when I do a snapshot lines up with my design

Thanks

Jimm

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.