Excited to test IP camera streaming using 2.1 RC. I have a Raspberry Pi 2.0 W and installed ustreamer (as suggested by support). I’m not a Linux guy and apparently I’m missing something. How on earth do you stream to a URL or IP address? Samples say to use a host of 0.0.0.0 and port 80 to “stream to the world” but my install says it cannot bind to 0.0.0.0. If I point my browser to the IP address of the ustreamer RPi, the connection is rejected.
I’m reasonably sure this is something somewhat simple, but darn if I can sleuth out the secret.
If it matters, I installed ustreamer using Snap as I have zero experience with a build from scratch - but if that’s the problem, I’ll redo it.
TIA for any assistance you can provide and Merry Christmas!
Steve
