Camera suddenly quit focusing nicely on items on honeycomb

LightBurn Hardware Compatibility Cameras
1

I am using Lightburn 1.7.07 on a thunder bolt laser. After 11 months (and shortly after upgrading to .07) my camera does not focus on the bed very well at all. I have tried moving the camera lens (ever so slightly each time) to focus better and found no relief. I have calibrated the camera thru my thunder…no change. Not only are the items I want to focus on blurred. but if I want to cut around an existing engraving, the lineup is terribly off.

any suggestions?

2

Is the camera lens clean?

4

Yes. I clean it fairly regularly, but made sure to clean clean - no change.

5

I do not use a camers, that was all I know. Maybe remove the camera and see if it will focus on anything else. Is there a setting in the Camera window related to focus?

6

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.