I’ve followed all the steps to properly align and calibrate my Lightburn camera but the cuts do not appear where I’ve assigned them. How can I troubleshoot this issue. I have a Bosslaser 1416 and 60mm Lightburn camera. Please advise.
1 Like
Can you show an image of your result?
Before you clicked the ‘Update Overlay’ button, did you adjust the height of the material so the top of it was at the focus point of the laser? (the same height as the top of the markers you ran when doing alignment)
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.