CamFive and 6442G-YM-B (EC) settings

In Aug 2021, a lightning strike took out my Comcast cable along with everything connected to it. I have a CamFive 5132 that was connected to the router. So the controller was ruined. Have a new Ruida 6442G-YM-B (EC) controller. It’s a CamFive proprietary controller but it works (almost) fine with Lightburn. The problem is the machine always operates at full power regardless of the layer setting. Lightburn is not able to control the laser power output. It also registers about 8-9mA when cutting (or doing simple lines). This is down from 18mA previously. Thinking there must be a setting somewhere on the controller.

Thanks.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.