ednisley
(Ed Nisley)
July 25, 2024, 11:11am
3
Most likely, there’s another device on the network with the same IP address, assigned by the router. You can ping that address and something will respond, but it could be either (or both) devices.
More discussion:
I’ve just spent a long time upgrading an old machine to a Ruida controller + lightburn. Almost everything now seems to be working, happy days.
One thing that is occurring which I cannot seem to resolve is that during complex jobs there often seems to come a point where the controller seems to lose position. A good example of this is a recent cut I did where in one layer in light burn I have a circle with leaves and vines and chains, etc some complex geometry. All gets cut quite well. In the nex…
HELLO,
I have a tech problem. My Omtech AF2028 stopped communicating via ethernet. I replaced the cable and still having message, Data not transferred, controller busy or paused.
checked IP Adress and replace cable
USB connection works fine
my modem and hub is fine
suggestions are seriously appreciated
Bob