The tool path is set to move horizontally when engraving (left to right along x axis).
Is there any way to change it so it moves vertically (up and down along y axis)?
Only reason I ask is because it would work better on my set up.
Thanks!
The tool path is set to move horizontally when engraving (left to right along x axis).
Is there any way to change it so it moves vertically (up and down along y axis)?
Only reason I ask is because it would work better on my set up.
Thanks!
Set the Angle in the fill to 90 (or 270) degrees.
Thanks guys! That worked.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.