While running a project on xtool D1 pro 40w the code line [xTool D1Pro:ver 40.31.006.01 B2] will come up the laser module will power down and will go to home.
I have the module set to return home after the run. What does this code line mean?
That’s a welcome message after connecting to the controller. What this means is that prior to this your laser has disconnected. You’re getting the welcome message at reconnection.
There are a wide variety of reasons why your laser could be disconnecting. I suggest doing a search on this forum for causes and remedies as this is one of the most common issues and fairly well covered.
Here’s a reference to a starting point:
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.