I have been trying to get my Anycubic Mega Pro laser engraver linked to Lightburn, and so far have not had any luck getting it recognized and functioning properly. I have manually connected it by the parameters given and all it keeps saying is the module is busy when its not doing anything on the printer. Could i please get some guidance in properly getting this established.
Not a Marlin owner, but I know the right questions to ask…
Only thing I could find was this from another posting. What does the Console window show when you first hook up the laser?
Make sure the baud rate setting is correct for your laser.
I will give that a try I even went and connected the port into comm 4 or 5 not sure witch off the top of my head
1 Like