Consistent Error of Check ALARM:1 Hard limit triggered. Machine position is likely lost due to sudden and immediate halt. Re-homing is highly recommended

[MikeyH (Mike Hembrey)]

I was looking for the G54 status that looked something like this…

Setting the G54 position

So, I did some further investigation and I came across a YouTube article by Barton Dring: Barton Dring - YouTube His explanation of “Understanding G-code Coordinate Systems” is superb: [Understanding G-code Coordinate Systems] I changed my settings from the earlier suggestion of: G10 L2 P1 Xval Yval to G10 L20 P1 Xval Yval, where I eventually set Xval and Yval to 0. Now, after homing my X-carve, my Origin is the same as the home position: $# [G54:-249.000,-249.000,-1.000] …

I do not know how to get this from your machine and am reluctant to suggest changes. @berainlb may be able to offer more suggestions.