Continious power mode


What are the settings to play with when not running continious power mode?
I often use vector drawings but in continious power mode the sharp corners aren burned too much.
When turning off continious power mode the sharp corners arent burnt enough.
Are there settings to play with to have some sort of minimum power in this case?
Or even better to define different powers at different speeds?



Grbl controllers don’t allow a min, max setting for power. I think they have to control it via software. I don’t spend time with my SS laser hardly anymore, but I never used that option.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.