Here are my findings after doing several print and cuts:
- The cutting at the corner of sheets where there are no registration mark is inaccurate.
- The cutting is fairly accurate at the center and near the areas where the registration marks are present.
I have attached several images illustrating the above. I had calibrated the X & Y of my machine before conducting these tests, hoping to produce more accurate results.
I think this might be solved if the print and cut has information from 4 registration marks rather than the existing two. I know that working out the feature might be tricky and would take a lot of time and effort, but maybe this feature could be a part of advanced Lightburn down the line.
