Creality CR-10S Pro

LightBurn Hardware Compatibility Marlin
1

Is there a way to save out light burn files in gcode that can be put on an SD card for the Creatlity CR-10S Pro? If not, what is the typical method used to use LightBurn with 3D printers running Marlin? When I connect the USB cable to the CR-10S Pro with LightBurn the printer keeps rebooting.

2

In the Laser window choose Save Gcode

image

3

I’m not sure if Marlin uses the DTR signal or not, but there’s a device setting for this - you can try toggling it to see if that helps:

image
image928×299 19.5 KB

4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.