Creality Falcon 2 Camera alignment issue

LightBurn Hardware Compatibility Cameras
,
1

After a successful camera calibration with a score below 0,3 and the Camera alignment done, It works.
Next day when I start up the Falcon and Lightburn, Lightburn ask me to do the Camera alignment again. I am using version 2.0.0.4

2

Once you successfully finish the calibration, make sure to export it to a safe place. Sounds like there might be an issue with settings storage, so export the calibration just to avoid needing to calibrate again.
Then you could try a clean installation, maybe.

3

Thanks will do that

4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.