Hi!
Small issue here, but quite annoying when I’m trying to launch every jobs at the same time.
I have a cut layer (line)
And a engraving layer (fill)
When I’m launching both jobs at the same time, the cut layer is going fine, but then, most of the time but not everytime, in a completely random way, the engraving gets misaligned, like there is a shift, not even everywhere. You know what might be the issue ?
I’m using a 6040 chinese laser with cohesion3D board and Smoothieware, engraving at 250mm/s and cutting at 4mm/s
Thank you.