Cuts in the wrong location / offset

[ednisley]

@ApexCrafter

This might be a Ruida issue

It’s likely you have a layout that triggers the Ruida “skewed engraving” gotcha, which boils down to the wrong polarity for the STEP signal.

A previous discussion on a similar problem and its resolution:

Image shifting and bunching up but cut out is OK

Red-Black 90w Laser Ruida controller engrave 400mm/s 25% Fill 450mm/s 20% Cut 25mm/s 65% Birch ply held down pins belts are tight so are stepper motors When doing a engrave/fill and cut I get the fill shift while the engrave bunches up, cut out in just fine. This is repeatable, and all come out the same, like it was meant to be, how do I attach image?