Hi! I have a project I need to complete by tomorrow. I’ve been trying to get this laser engraver to work all week and I’m at a standstill. I can add the Device but instead of showing “ready” like in all of the videos it shows “disconnected” … any suggestions?
Right click on the ‘Device’ button in the ‘Laser’ window will attempt to reconnect.
If Lightburn can find it for the setup I should connect. Do you have the right device selected next to the ‘Device’ button (far right.)
1 Like
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.