Distorted picture

I set everything up as it is written in the book and I have a distorted image in width. Why? Sculpfun S9 Lightburn 1.2.04

  1. Screenshot by Lightshot
  2. Screenshot by Lightshot
  3. Screenshot by Lightshot

This is usually caused by wrong firmware settings. How you can change them and which values need to be set can be seen here: Firmware Update & Settings - Diode Laser Wiki
Especially, check values $100 and $101 (x and y steps per mm) which should be set to 80.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.