Dithering with ortur lm2?

I’m new to light burn and lasers in general. I was using the free GRBL software with my ortur LM2. Trying lightburn for more options

My problem is that I can’t figure out why my laser is firing as it would normally burn but nothing is being engraved. Like the power is way too low.

Running windows 10 Lightburn 0.9.24 and an Ortur Laser Master 2.

This is worth review: Common Grbl Setups - LightBurn Software Documentation

As well as the instructions and resources here: Ortur Laser Master 2 – Ortur

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.