Documentation for the Camera Control panel

LightBurn Hardware Compatibility Cameras
1

I looked through the documentation and couldn’t find much info on the Camera control screen and none at all about the Width/Height, X shift, Y Shift settings, Trace or Save options! I found a post about the width/Height and Shift settings but nothing on the Trace and save.

Will the documents but updated with this info? I know that development is high priority but I think if the documents are updated it would could save a lot of questions (and time answering them).

Camera%20Control-1
Camera Control-1.jpg702×738 145 KB

1 Like
2

Trace is to take the bed capture image and run it through the bitmap trace feature.

Width, Height, and Shift are to fine tune the camera alignment if necessary (it usually isn’t) and Save is to save those settings. I’ll make a note to update the docs.

3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.